How can I add filets to board cut-out?
Hi, I was searching a bit, but i couldn't fidn a soulution. How can I add filets to edges of my rectangle in board cut-out? I marked with bright red color, i want to filet those corners. When I select edit points, I have 0,1,2,3 - Number of points, and there i can only assign an arc value to points 1,2,3, and the arc value doesn't = the one I input. #PCB#
ESP32-s3-Wroom and micro usb DRC clearance issues
https://www.lcsc.com/product-detail/WiFi-Modules_Espressif-Systems-ESP32-S3-WROOM-1-N16_C2913199.html Hi I've made a simple schemaic for ESP32-s3 wroom and micro usb But then I auto-route, and check DRC I get one line not connected (grounding pad under ESP32-S3) and vias around that pad don't have enough clearance. Also microUSB https://www.lcsc.com/product-detail/USB-Connectors_SHOU-HAN-MicroQTJ_C404968.html These little plastic prongs that go into the board, also dont have the sufficient clearance from the metal side pads these are the errors I don't really know how to solve them. Can someone guide me how to fix the issues? I'd prefer to have vias directly under the ground pads, so i could fill them with solder from the bottom side since I dont have a hot air station. #PCB#
Solder mask on bottom layer
Hi, I've designed a simple 2 layer board. I have a few tracks going on the bottom layer and connect to top via VIA's. Now when I looked at my board in 3d and 2d the bottom layer has mask on. I proceded to order my pcb, but the representative conntaced me with this message: 1. pls revise the gerber files and re-upload online 2. cover the whole bottom side with soldermask When I go into my bottom solder mask layer and draw a rectangle over the whole board -> i view it in 2D no solder mask is on bottom layer. I export gerber view it, no bottom mask How can i fix this? #PCB#