asdasdasd
When moving component on PCB layout traces do not stick to component
When I move a component on the PCB layout the connected traces do not stick to component. Is there a way to prevent the traces to disconnect when I move a component? #PCB#
bitterandreal 2023-11-29 01:15:56 comment 1 0 Circuit Design
ST-link V3 MINIE B2B connector footprint
I want to use the ST-link V3 MINIE B2B connector but it requires a 0.6mm slot. JLCPCB allows only 1mm slots in the outline layer. Plated slots drawn with a pad are allowed with 0.5mm width but I'm worried about the distance between the plated slot and the two pads next to it. I selected no plating in the pad settings but not sure if JLCPCB actually sees this in the fabrication files. Has anyone experience with a similar slot? #PCB#
bitterandreal 2022-11-23 04:11:37 comment 6 0 PCB