Use of Jumpers in easyEDA
Hi folks, I need 15 Amps running continuously through my pcb wires. As often as possible i design the same power wire on both sides of the pcb, as large as required, and add suture vias. And more, sometime a "solder mask" line on the power wire is drawn, to add solder for the pcb wire to get thicker. But this time the opposite wire cannot be drawn for a short lengh (approx. 2cm) and i'd like to use a JUMPER wire. I have put two vias where i will solder the jumper but i'd like it to appear on the PCB, 2D and 3D views. Found no such device in the libraries. Does anyone know how to do that within easyEDA ? Thanks, #PCB#