asdasdasd
Auto Router Not Routing Within Vcc Layer in 4 Layer Boards
Hello, I am using the Auto Router to route a 4 layer board. The inner layers are copper areas set to Vcc and GND. In the auto router I checked both layers to be used for routing. After the router is done (with failed connections), there are traces in the GND layer but the Vcc layer is entirely unused. It was easy to add the failed connections manually to the Vcc layer. But my question is, why does it not use it for routing, but rather gives up with failed connections? What am I missing? Thanks much in advance for your advice! #PCB#
bm8000 2021-02-22 23:20:36 comment 0 0 Circuit Design
How can one design a thermal pad 'under' QFN footprints with exposed die pad?
Hello, I am trying to create a thermal pad on the other side of the board below this footprint: QFN-28_L5.0-W5.0-P0.50-BL-EP The JLCPCB component with this footprint is a stepper motor controller: https://lcsc.com/products/Motor-Drivers_611.html?q=tmc2209 I tried to generate an exposed copper area on the bottom layer underneath the footprint. Then I tried to use 'Add/Rmove Vias' to create an array of vias between the exposed die pad and the copper area on the bottom layer. Unfortunately, this does not seem to work. I can only generate vias when I make two copper areas, one on the top layer and one on the bottom layer. Then the vias appear properly. But between a 'pad' of a foot print and a copper area the 'Add/Rmove Vias' tool does not seem to work. What am I missing? Is there a work around? I thought of using a QFN footprint without the exposed die pad, and then creating a separate grounded copper area instead of the pad. But that seems a bit 'inelegant'..;-) Any input would be greatly appreciated! Thanks much in advance! Thanks! #PCB#
bm8000 2021-02-17 20:34:15 comment 3 0 Circuit Design
What Does Cloning an Entire Project Do?
I tried to copy an entire project with all its schematics and pcbs via the 'clone' function, and nothing happens. When I clone an individual schematic it works and makes a copy of that schematic....but it seems on the project level the function does not do anything (except producing a happy 'project has been cloned' message on the right side of the screen). Am I missing something? Any clarification would be appreciated! #GeneralDiscuss#
bm8000 2021-01-05 22:03:07 comment 3 0 Others
Cutouts That Show in 3D View are Not Showing Up in Gerber Files Uploaded to JLCPCB
I am trying to design a PCB with an odd shaped cutout in the center. I am using the 'Solid Region' tool, and I switched the 'Attributes' to 'Board Cutout' and 'Multi-Layer'. When I select the 3D view, the cutout shows up nicely. However, after downloading the Production files and uploading to JLCPCB the cutout is not present anymore. I would appreciate any help with this. Thanks much in advance! #PCB#
bm8000 2021-01-01 21:53:20 comment 6 0 Circuit Design