How to convert a shape to a Copper area
Good morning. I am trying to create a copper fill area and would like to use a specific shape that is already drawn vice freehand with the mouse, Specifically, I have a teardrop shaped piece and I would like to create a 0.25" copper fill ground area all the way around the edge. Is there a way to covert a line or group of lines to make the copper area? TIA #FeatureRequests#
Recommended wire/trace thickness for automotive use
Good morning from Kabul! Yes, Kabul, Afghanistan (I work at the Embassy). Anyway, in my down time I am teaching myself coding for Arduino and circuit design for the Arduino project. In a nutshell, I am going to be using vehicle power (car battery) to power a circuit board via voltage regulator and will be moving the 12vdc thru some TI automotive load switch ICs. What I do not want to happen is the wires (trace lines) to act as a fuse because they are too thin/small. EasyEDA defaults to 0.01" (0.254mm) traces. I plan to power the radio, headlights and interior lights with this circuit. Using the JLCPCB defaults for PCB fabrication (1.6mm board, 1oz copper, HASL, etc.) and an Optima Yellow Top H6 Batteries 9048-148, what trace thickness is recommended? I am sure there is some formula to figure this out but I do not know. TIA! #PCB#
How to place a "pad" in the schematic view
good morning. I am designing a circuit that requires six wires to be soldered to the board and I do not know how to insert a Pad in the schematic/sheet view. I can place them in the PCB view but they do not appear in the schematic view. the projects is not complete as I am also waiting on some part designs to be completed by LCSC and looking for options for a TI automotive load switch chip. i think i shared the project correctly: https://easyeda.com/editor#id=0a5b71f9bedf42bba0d361121d3f5dc0 #Schematic#