Routing Failure on a complex schematic
Hi I am actually new to easyeda. I had an old project that worked fine. Than i improved addinf some components and therefore more wiring. This time only one fraction of the routing (lots of wire) is done. What are the available options please ? Best regards #PCB#
ESP32 wrong footprint during schema to PCB conversion
Hi I am trying to design a pcb using esp32. When I select the component (ESP32-WROVER-E(4MB)_C701347) to insert it on the schema I can check the preview is correct but during the transition from schema to PCB the footprint changes...which is a bit of a problem. Do you have any ideas ? Best regards. #PCB#