Two PTH in oval pad, one hole oval, is this acceptable?
Hello, I'm trying to design a PCB on which I would like to have two plated through-holes, one of them being oval, sitting on the same pad (or at least connected by a trace). Is such design acceptable, following JLCPCB's capabilities? I noticed this thread: Oval pad with two holes, which gave me some answers, and I also checked JLCPCB's capabilities, but I am still unclear whether the dimensions I am using are acceptable... I would really appreciate getting your input on this. Here it is in "resources": OVALPAD2HOLES, and this is what it looks like: Thanks in advance for your very precious help. Update: I learned that I can edit a post, but I cannot edit/delete a reply. So I'll put the additional info here too: I noticed this rule in JLCPCB's capabilities: The minimum plated slot width is 0.65mm, which is drawn with a pad. The slot in the screenshot above was only 0.6mm wide, so I increased it, as well as the round hole diameter, to 0.65mm. I kept both annular rings to 0.4mm, so the two holes are still 0.8mm apart. You can check the updated OVALPAD2HOLES resource. #PCB#