asdasdasd
How to add a gain trimpot to this onboard bass preamp?
I'm currently trying to replicate this Yamaha BB5000A preamp but i wanted to add a gain trimpot since it was designed to be paired with active pickups. Active pickups have much more output and they are quite rare to be used in a bass. I was wondering if it's possible to add a gain trimpot to make it a "passive pickups friendly preamp". It's a 2 band preamp that uses 30k linear pots, since it's quite difficult to find this value, is it possible to change them with a more traditional 50k linear pots? It's a single layer PCB and this is my first time trying to trace. Once it's all done i will rearrange the geometric disposition of the components to make it smaller and double layer. I add a square pad which is the ground (to avoid soldering a cable direclty to the bass pot). B stands for "bass", T for "treble". I don't own this preamp, a friend of mine lend my his Yamaha. Here it is my project: https://oshwlab.com/difesa98/yamaha-bb5000a (you can find all the value in the excel file) #Schematic#
difesa98 2022-05-16 16:37:29 comment 8 0 Circuit Design
Netlabel Problem
Hi! i'm trying to build a THT version of the onboard preamp Aguilar OBP-3. I'm new using Easy Eda and i cannot figure how to solve this netlabel problem for V+ and GND. I've also done a smd version and it doesn't have this issue, all i have done is replacing the parts one by one and i used pads instead of connectors (since this is quite bigger i wanted to save space). Here it is the project with the schematics: Aguilar OBP-3 THT I used the autorouter for this project, is it reliable? for a 45x50 mm board it used 1700 mm of copper, maybe it could be a problem in term of noise? When everything will be ok, how could i obtain the frequency response of this preamp? Here it is a diagram made by Ibanez for the original one. Thank you for any advice! #PCB#
difesa98 2022-03-29 23:20:26 comment 7 0 Circuit Design