asdasdasd
Trying to get my first schematic to run
So it is my first schematic and I'm trying to run it. Here's the schematic: https://easyeda.com/djays12/Tachometer_electronics-076dcb60fc8f48358604c85fbfbcc000 I've already replaced the NPN transistor (it used to be a BCW66G) for a generic model that can be read by spice. Mainly the circuit is a frequency/voltage converter that will be used to convert a 0-267Hz square wave signal into a 0-1.6Vdc voltage. The output of the LM2907 is then boosted through a op amp and a transistor to be able to output enough current for the load (an electromagnet, that I replaced by a inductor in the circuit). This circuit will be used to power a tachometer (the electromagnet is acting on the needle and fight again a return spring). The message error I get is as follow: Circuit: gooduntitled Doing analysis at TEMP = 27.000000 and TNOM = 27.000000 Warning: v2: no DC value, transient time 0 value used Warning: singular matrix: check nodes u1_2 and u1_2 Note: Starting dynamic gmin stepping Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Warning: singular matrix: check nodes u1_2 and u1_2 Warning: Dynamic gmin stepping failed Note: Starting source stepping Warning: singular matrix: check nodes u1_2 and u1_2 Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful gmin step Note: One successful source step Warning: singular matrix: check nodes u1_2 and u1_2 Warning: singular matrix: check nodes u1_2 and u1_2 Warning: source stepping failed DC solution failed - Last Node Voltages Node Last Voltage Previous Iter ---- ------------ ------------- xr2_2 0 0 r1_1 0 0 u1_1 0 0 v1_1 0 5.8766e-118 r1_2 0 0 u2_6 -1.52529e-103 -1.38638e-117 volprobe1 5.35177e-104 7.98716e-118 l1_1 5.35177e-104 0 u1_2 0 0 l1#branch00v1#branch 2.51539e-115 0 v2#branch 0 0 doAnalyses: iteration limit reached op simulation(s) aborted Error(parse.c--checkvalid): volprobe1: no such vector. ngspice-26 done Anyone have an idea on what I did wrong? #Simulation#
djays12 2017-07-01 03:11:57 comment 18 0 Circuit Design