asdasdasd
Issues with snapping with Measure tool
In the past week or two, something has happened so that, when using Measure, the tool no longer snaps to the origin points/center points of objects. There used to be a little white dot that would show up when you hovered over the center of an object and the measure tool would snap to that, but I don't see that white dot anymore and the measure tool doesn't want to snap where the white dot should be. I checked in the settings tabs and there doesn't seem to be a setting regarding this, how can I get it to work like how it used to again? Thanks #PCB#
drewtstew 2022-05-23 13:10:14 comment 4 0 Circuit Design
Creating an oblong hole with EasyEDA
Are oval holes possible with EasyEDA software? I have tried putting several holes next to each other, but can't get it to look quite right. edit: I actually just stumbled on putting one-off pads onto the board as a possible solution to this problem, has anyone else had any luck with this? #Skill#
drewtstew 2021-07-26 19:45:19 comment 2 0 Circuit Design