Check pcb wiring
At the moment when I place the pointer on a section of pcb track it is highlighted between the two nearest pads. Is there a way of highlighting the complete track from start to finish? #PCB#
size of schematic window
I created a schematic module comprising an integrated circuit, several resistors, diodes and terminals. I then wanted to create a new schematic using 8 copies of this module, but the copies occupy an arear larger than the standard schematic sheet. Can I shrink the module or increase the size of the schematic sheet? #Schematic#
pcb footprint
I am trying to create a pcb footprint for a relay that is not listed in the libraries. I can create a schematic symbol and I can create a pcb footprint, but how do I link the two together? #PCB#
PCB and parts
When placing an order for a pcb can I also order the parts? How do I do this? Do I have to place 2 separate orders? - one for the pcb and one for the parts, or can it all be included in the pacb order. Eddie Price UK #GeneralDiscuss#
connecting segments of pcb track
I use manual layout of tracks for my pcb. Sometimes I end up with several segments for a single track. This also happens when using a via to connect track on one layer to a track on another layer. It is then only possible to highlight each individual segment of the track rather than the whole track. Is it possible to connect multi segmented track so that the whole track can be highlighted? It would make visual examination of the connections much easier. Eddie Price UK #PCB#
Top and bottom track layers
This is my first attempt at using EasyEDA. I have created the schematic and then the PCB layout. I would be quite happy with a single sided board. I am using through hole components including DIL packages. Can I assume that the red TOP layer tracks will correctly align with the DIL pins, ie. the DIL packages will be on one side of the board and the copper tracks will be on the other side and will be correctly aligned with the DIL pins. I have included solder pads and have used the blue layer to show the location of wires that will cross over the copper track where cross-overs are needed. The wires will be on the same side of the board as the components. #PCB#
Newbie
I am new to EasyEDA. I have managed to create a schematic and converted it into a pcb. First : I have difficulty moving between schematic and pcb eg. when in the pcb editor how do I move back to the schematic? Second : On converting to the pcb some of the electrolytic capacitor pins connections are reversed, eg. positive goes to ground. Can I change this in the pcb editor, or do I have to go back to the schematic? Third : In the pcb editor can I manually route tracks? Eddie Price #GeneralDiscuss#