Copper fill with pads with large solder masks.
I created a large component. The pads are 2mm hole with a solder mask of 2mm. The copper fill is going right up to the solder mask. Example, Create a pad with a 1mm hole, and a solder mask of 0.5mm. Then do a fill with a clearance of 0.5mm. Notice it did not keep 0.5mm clearance around the pads' solder mask. This appears the copper fill tool does not take into account the solder mask size when calculating clearances. Or am I doing this wrong? #PCB#
Copy existing PCB from a scan
Vintage arcade monitors have quite a few heat generating parts on them. Over 20-30+ years of being powered on, the heat causes the traces to lift off the boards. I would like to import a scan of the board (they are all single sided) into EasyEDA, and use it as a template and trace over the image, and get a new board made. But when I import any image, it turns it into a very bad white silkscreen version lacking the details I need to trace over it. Is there any way to import a image without converting it to a silkscreen? #PCB#