asdasdasd
Bare copper traces needed
I need traces to be bare copper so that I may add solder on top of the traces, so that it can support more current while keeping the trace width. How might I go about this? #GeneralDiscuss#
etimmon2 2018-06-20 07:14:41 comment 1 0 Others
Connections between components are not made when converting to PCB
I just finished putting together the schematic for a 2N3055 and LM317 based power supply, and though all connections are made in the schematic (as far as I can tell), when the schematic is converted to a PCB, the blue lines indicating connections between components only connect to one pin out of two of several components. This leads to there being a free floating lead, even though it should be connected to other components. Auto-routing does not make the connections. This very well may be user error, but I don't know why the connections aren't in the PCB, but are in the schematic. The Project Note; Please take a look at the schematic, then go to the PSU1 pcb layout. You should notice that several components, (D1, D5, D7, D8, D9, D10, C18) have a leg that is not connected to anything. Any help would be greatly appreciated. #GeneralDiscuss#
etimmon2 2018-06-18 23:01:39 comment 2 0 Others