asdasdasd
Pin - Pad assignment
Hi, is it possible to assign a pin to multiple pads ? If yes how ? I used in my project a SX1509 component (not done by me) and the GND pin should be connected to pads 3, 17 and 0. Easyeda gives me an error on GND pin (see picture below), initially all the 3 pads were written separated by space (eg. 3 17 0), I tried to separate them by comma, yet the error remains. How can I correct this ? #PCB#
fededim 2020-05-11 15:50:01 comment 2 0 Circuit Design
Allow the specification of track width directly in schematics
Basically, the idea is to allow the user to set the track width in mil on each Wire directly in schematics (or equivalently set the maximum current in amps). In PCB editor autorouter feature could automatically get this value and adjust consequently the track size, , if "width" field is unset the wire will take the default autorouter's width. This would be a very useful feature because usually tracks transporting power should be thicker than tracks dealing with signals; as for now you have to go into pcb editor and set manually the track width for each wire and when dealing with complex circuits it can be too cumbersome. #FeatureRequests#
fededim 2017-05-04 06:05:04 comment 6 0 Feature Requests
Unable to save schematics
BUG Concise problem statement: Unable to save any changes to a schematic, EasyEda website always returns "Network Error". Obviously there are no network issues since internet browsing is working and also searching components data in EasyEda works flawlessly. Steps to reproduce bug: Change something in schematics Try to save Results: It always returns "Network Error" Expected results: The schematics is saved. Browser: Chrome 58 #BugReports#
fededim 2017-05-01 01:35:08 comment 9 0 Bug Reports