asdasdasd
Can't open offline projects - HELP, pls ...
All offline projects have gone - since weeks! - Data directory is existing, project files are axisting, - path to data dir is set correctly, - run mode is set to Project Offline Mode but I can't open any project as they are not displayed in list of offline projects - the list is empty! And it stays empty even after .... 1. CLEARED Cache 2. CHANGED Project directory: copied project sub directories to a differend file system directory and than changed the data drectory path in easyeda accordingly = didn't work 3. NEW Installation: uninstalled easyeda-std, rebooted, and installed again = didn't work What's the problem??? I also have the PRO version installed on the same notebook and I played around with that version, also tried importing projects from standard version - maybe that's relevant? #Others#
fittyfu 2023-11-09 23:27:48 comment 4 1 Others
Suddenly no offline projects available, but existing on file system
Hello, EasyEDA doesn't show any offline projects, but there should be plenty projects as before. The directories and files does exist in file system, the data directory in EasyEDA is set correctly. How do I get my projects back into EasyEDA and what happend??? #Others#
fittyfu 2023-10-15 21:09:59 comment 14 0 Others
footprint pads with wrong numbering (SOLVED)
I've created a simple module for esp32 MCU, but ran into problems when working on the footprint. During creation I copied the bottom row of pads to the upper row and changed the numbering of the upper pads. The lower row started with pad no. 1 to 16 and the upper row should go from 17 to 32. But after changing the upper rows numbering, the old numbering seems to exist in parallel to the new assigned numbers, Looking close to the first upper pads, you can see the old numbers between new numbers. There is a "1" between the "17" and a "2" between the "18": You can also see the ratlines between the lower and upper rows of pads - they are senseless and don't belong to there: While the pads (18) properties seem to be correct: What's wrong? #PCB#
fittyfu 2023-08-16 13:50:10 comment 4 0 Circuit Design
DRC (design rule check) suddenly shows errors with via diameter -
Hello, I'm not sure what happend, but since today I get errors from the "Design Rule Check" DRC, telling me that diameter of my vias is too small. Please see the bottom of the following image: Is that a round-off error ( 24mil and 24.016mil)? Here are the DRs: Why do I get the error messages and how can I avoid? #BugReports#
fittyfu 2023-07-18 21:22:12 comment 1 0 Bug Reports