asdasdasd
Auto-Router layer preference
Brief title for your desired feature: The "special nets" menu should include a "preferred layer" for a given net. How would you like the feature to work? The pathfinding algorithm for the autorouter would consider it drastically "cheaper" to put a net onto the preferred layer. It would still use any layer it has to to complete the routing but if possible it would use the preferred layer. Why is this feature important to you? It makes it simple to use all the copper on the board with minimal human labor. Just tell the autorouter to "prefer" the top of the board for ground (since most chips have more connections to ground than VCC), the bottom of the board for VCC. Then, flood fill. Those traces for ground now get to use the entire remaining layer of the board for maximum conductivity, and vice versa for power. This feature would work even better if the GUI were designed to suggest this or make it easy. "autoroute, with GND to top and VCC to bottom, followed by flood fill top and bottom set to GND and VCC respectively" is probably the best way to make most simple boards. #FeatureRequests#
gerald.monroe 2016-04-30 08:23:29 comment 2 0 Feature Requests
Size errors with standard footprints
BUG Concise problem statement: The "Inductor-1206" package is the wrong size (way bigger than it should be). The R1206 and the C1206 are not the same size - the actual definition for these footprints says they are the same. Steps to reproduce bug: Place a capacitor and a resistor down. Choose R1206 and C1206 for each one. See, different sizes. Good luck getting parts to fit. Results: Expected results: Browser: #BugReports#
gerald.monroe 2016-04-21 15:07:18 comment 21 0 Bug Reports
Copper Area menu is not appearing
I tried to follow instructions to fill my board with copper. No matter what I did, the selected area selection box does not turn white, and no menu to adjust anything appears on the right hand side. I have tried 2 different web browsers - I think it's a serious bug on your end. Without the ability to copper fill, I cannot complete the board. #BugReports#
gerald.monroe 2016-04-11 17:18:47 comment 2 0 Bug Reports