asdasdasd
Rectangle hole, placed in a rectangle top layer pad
Any suggestions of how I can place a rectangle hole through a top layer rectangle shaped pad on the PCB? I can't seem to figure out how to do this. I can do this with a multilayer pad, but I need the hole edges not rounded. Ideally I would like the pad to be a top layer pad. Multilayer could be used as a second choice. The main issue is the rounded edges of the hole. Thanks! #PCB#
gmperf 2019-03-18 23:54:39 comment 2 0 Circuit Design
Pads with non plated holes
What am I missing? I want a pad on the bottom layer, with a non plated hole through it. When I put a pad on the bottom layer and them add a hole diameter to the pad properties, the pad them becomes multi layered. If I change the pad properties back to bottom layer, the hole size goes to zero. If I put a pad on the bottom and then put a hole though it. the hole then becomes plated and electrically attached to the bottom pad. I have had two PCB boards made. One has the Pad holes plated, one doesn't. When i look at each PCB layout side by side, the settings appear the same for the pads and holes on both boards. Yet one has plated holes and one doesn't. Any help would be greatly appreciated! #PCB#
gmperf 2018-08-23 04:34:23 comment 12 0 Circuit Design