p-channel high side mosfet help - switching with 3.3v
I have this circuit using an n-channel mosfet to basically enable a ground connection for a device by switching 3.3v from a pi pico. This works well but..... I also have a requirement to switch 12v to a horn (the horn draws about 5 amps) from a logic 3.3v I am lost as to what the circuit for a high side load looks like, can anyone make a suggestion? This is a noob type qustion but I find online many alternatives but I dont know enough to say which I should use. All help and discussion welcome thanks in advance, Gus #Schematic#
Import from standard edition, netlist failure
I am opening the pro version and use the std/pro icon on the dashboard. When I open the imported project and open the schematic and PCB files all looks great. As a confidence I select update PCB from schematic and it fails with many netlist failures what am I doing wrong? #PCB#
3.3V solid state switch to switch 300ma at 12-15V
Hi all, I am building circuit which involves switching a standard 12V auto relay my processor is an pi pico which produces 3.3v on the gpio. I could use a 3.3v relay but I would like to use a MOSFET to switch instead because of the environment in which it will operate. Could anyone help me out with a suggestion for a circuit/BOM that might serve this task. I am not experienced with MOSFETS and rather than blow up several while trying to figure it out I thought I would ask here? Thank you in advance, Gus #GeneralDiscuss#
Simulation of a SPDT relay
I am sorry I am sure this has come up before but how do I simulate a relay? #Simulation#
Simulate a SPDT relay
I am sure this has come up before but I am totally lost, how do I simulate a simple SPDT relay ? #Simulation#
ESP_PICO_D4 access to the ground pin?
I am quite new to this but I am having an issue with This component the footprint is below. No matter what I try the autorouter will never find pin 49 the only ground pin on the chip (49 is in the middle). I wont ever understand why espressif didnt place ground on the external pins but hey. #PCB#
esp32 pico d4 multi layer
I want to ask, what is the smallest viable via size (radius and hole size) that I can use? I want to used an esp pico d4 with multi layer vias has anyone ever done this? Thanks in advance Gus #PCB#