asdasdasd
Can't get back to 45 degree clean corners -- everything is now rounded after update
I updated EasyEDA Pro yesterday, and now I can't get it to draw nice clean 45deg traces. EVERYTHING is now rounded. I've tried dozens of settings (see below) and all I get are rounded corners everywhere. I'd like to get it back to drawing traces like in the second photo. I'm at the end of my rope, I've tried everything. Have been working with EasyEDA Pro for years, so I know it very well. These are tests of every corner mode for three routing modes -- I never could get a good clean square or 45 degree corner. This is what I'm trying to get back to, but no amount of changing Routing Mode or Routing Corner will do it. #PCB#
h.eskin 2026-10-16 04:26:04 comment 2 0 Circuit Design
Auto router creates tracks for GND, but I want to use VIAs to the GND plane instead
I have a lot of components on my PCB and most of them have a GND connection. When I run the Auto-router (local), it creates tracks for every GND connection -- making routing the other signals much harder. I would like to for each component put a locked VIA that connects directly to the GND plane (bottom layer of 2 layer board). But I can't see how to do this. Even if I place the GND VIAs and LOCK them into place, the router still routes those to tracks all over the board. I would like to avoid that routing and only use the VIAs to the GND plane for ground connections. Thanks (see following comments for a better expression of the feature request)/ #FeatureRequests#
h.eskin 2022-02-23 06:56:24 comment 9 0 Feature Requests