touch pad design
Good day everyone, i'm struggeling to design a touch pad/button. i'm trying to design a touchpad with graphics integrated. the following happens everytime. if i'm using a pad in pcb designer, i dont get a soldermask on top. if i'm designing one with images, i'm not getting it to connect to my net/pin. is there a way to make a pad from image? if yes is there a way to put soldermask on top? of course not using solit, this will take to long for my design. my goal to achieve is: if i make a touch button. i don't want copper to be exposed(obvious reason statics). and i want to have a image inside of the pad where there is no copper nor solder mask. i did read a lot of forum post, watched tutorials. but i cant seem te find a solution. can someone give me a direction to look for? thank you #Skill#
6 pcb on one
hello, first of all thank you for this software its nice to use. i cane across one problem. i did search the forum but could not find what i was looking for. i designed a pcb. i tried to copy this 6 times to put on one pcb. but then i get those ratlines. that won't go away. i searched the forum. i found you could make a pcb module. so i did, but then i'm placing 6 of them on one pcb. i get the same problem. (ic's and such count up, like u1 becomes u2 etc). but the againt i get thore ratlines. i know the pcb's are drawn and i dont have any drc faults or any, is it a problem those ratlines? because a single pcb has its connections. would jlcpcb make a problem out of it? or maybe someone can give me a direction to look for? thanks in advance. #PCB#