asdasdasd
Spice Sym Warning for missing spice data
Hello I am very new to easyeda and built a simple project based on a subckt page with a DC sweep, diode and resistor in series that i ran the spice simulator against. Unfortunately the vprobe spice sim data returned did not fit the expected diode simulation response and i spend some time fiddle with it before i gave up and asked support for help. Well it turn out that i had selected a component from the eelib and it does not contain any spice data hence not proper results. So maybe if possible for beginners like myself it would be nice to have a error/warning message returned saying NO Spice Model Data use components from ????? please! BIG Thanks to Andy for the heads up Many thanks in advance Ian Knight #Simulation#
ianknight 2018-11-07 23:48:10 comment 0 0 Circuit Design
Copper Pour Undo Does Not Seem to Work
BUG Concise problem statement: Steps to reproduce bug: 1.Draw a simple PSU schematic with a GND, a 7808 V Reg, two caps and Wire Pads is good example Create a bottom layer PCB, manual or auto route Do a copper pour to bottom lay (Works Fine) and then do UNDO Results: The Copper Pour is not removed (UNDONE) Expected results: Copper Pour would be removed Browser: #BugReports#
ianknight 2018-03-06 19:02:04 comment 8 0 Bug Reports
Is there any help or guide on how you do copper pour
Spent hour trying to figure out how to do copper pour on gnd net. Is there a how to guide please? #PCB#
ianknight 2018-03-05 10:47:14 comment 3 0 Circuit Design