Serial Numbers?
Is there an option to have the PCBs numbered during manufacture with silk screen? Example: Filter 001, Filter 002, etc. I don't see it in the documentation, and I didn't find any similar questions. Thank you for your time! #PCB#
Prefix defaults to "NO"
I'm using the desktop version of the standard EasyEDA, 6.5.22. I have a 2 pin connector created in my Symbols library, with the prefix set as "J" (J? in the editor). I have a footprint in my Footprint library with the same "J" as the prefix. However, the prefix is not associateing with the Symbol or the Footprint. There is a "NO" in the Prefix box: The "NO" follows through on the schematic as well as the board. I've never had this issue before, so I'm not sure what to try to correct this. Any suggestion are appreciated. Thanks - #Schematic#
Is V-Scoring offered on non-panelized boards?
Does EasyEDA offer v-scoring to a non-panelized board? If it is, how would I indicate this on the PCB? I'm trying to find a way to add a v-score, both sides, to a PCB. I have a design that converts Character LCD pins to a ribbon cable. Some LCDs have 0.100" pitch, some have 0.050" pitch. I have both pitches on the same board, and it would be nice to be able to snap the board in half at the "CUT" line indicated in the picture. Is there a way to do this without panelizing the boards? Maybe use a groove as a board cutout and leave very little material at each end of the groove? #PCB#