asdasdasd
Question about four-layer PCB
I'm working on a project that uses a four-layer PCB. My idea is to distribute the layers like this: Top layer: 12V and signals such as dir, step for tmc2209 driver. Inner1: Complete ground (GND). Inner2: 3.3V. Bottom layer: Complete ground (GND) connected with multiple GND pins from inner1 and Bottom layer. Is this configuration correct? #PCB#
ivanete8888 2026-05-08 10:32:51 comment 4 0 Circuit Design
Publish video and more photos in my project.
Hi everyone! I recently posted a project, but I can only upload one photo of the 3D PCB and another photo of the fabricated PCB. I've seen many other projects on oshwlab that include lots of photos and even a video. How can I do that too? I'm getting a warning that videos can't be attached to my files. Thanks for your help. #Project#
ivanete8888 2026-05-02 04:01:16 comment 6 0 Projects
Error when I want to make larger tracks for the vcc and gnd network
Hello everyone. I am new to using EasyEda and I have a question. I want to create a board to control four steppers using an Esp32 and TMC2209 drivers. I already have everything designed and created, but I need the vcc and gnd tracks to be thicker since when the four motors and the logic part of the drivers and the Esp32 are fully operational, there will be a consumption of about 5 amps. I don't know exactly how thick my tracks should be to withstand those amperes, but if I route it with, for example, two millimeters, some errors are generated. I have tried to route only the vcc and gnd tracks with that thickness but I have not succeeded, all the tracks are routed. It is not very well understood how to use the routing rules options. So basically I have two questions: How many millimeters should the tracks be for vcc and gnd for five amps? How can I route only the vcc and gnd and stepper motors tracks with a certain thickness and the data tracks with a different thickness? Some images: Thank you. #PCB#
ivanete8888 2024-06-24 19:57:27 comment 12 0 Circuit Design