asdasdasd
NodeMCU 4ch relay Advice
Hi I have designed a 4ch relay for myself, and was hoping someone could give it a check, I have tried to figure this out as I go and is the most electronics design I have ever done. I would like to create a 4ch relay controlled by a NodeMCU on one PCB. The relays will operate garden LED lights It will have 2 manual switches and respond to HTTP Post To keep things tidy I gathers all the neutrals together and one Live input that is on the COM for the relay. Just feeling a little unsure before I move on to the next step. my project Thanks for advice. Jasonmilly #PCB#
jasemilly 2020-11-01 19:18:17 comment 23 0 Circuit Design
How to know which way a screw terminal is facing? track to pad errors after moving an item
Hi when placing a screw terminal on the PCB what direction does the half circles represent? Also when I rotate the terminal I then get a track to pad error, is their a way to correct this with out deleting the track and then redrawing it? many thanks #PCB#
jasemilly 2018-06-26 19:43:36 comment 6 0 Circuit Design
set distance between wires ?
On one of my first schematic's, I have a lot of wires coming off a bus. Is it possible set a minimum gap between them rather than me manually move each around until they look something like the same when I drop a resistor on each wire it looks very cluttered. thanks Jasemilly #GeneralDiscuss#
jasemilly 2018-06-08 23:15:48 comment 1 0 Others
First timer first schematic advice and feedback please
Hi Everyone I am pretty new to electronics and have the first Arduino project that I would like to move off the breadboard. finding this site has been a real find as I searched the internet on making your own PCB's, I have followed the tutorials and read through the forum. I have created my first schematic, all I want to do is create a pcb that removes all the wiring between my MUX74HC4067, provides 5 volt access for the switches and gathers all the Grounds together. Questions Have I made a silly mistake Do I need to show the switches (I don't think so) How do I show the 5 volt power that all the switches will wire into with power provided from the 5 volt pin off the arduino. Sorry if my terminology is off all help is greatly appreciated. Link to project my first schematic thanks JaseMilly #Skill#
jasemilly 2018-05-28 19:04:51 comment 1 0 Circuit Design