asdasdasd
Track with multiple widths
I have a PCB where some tracks have different widths because on some parts of the track higher currents occur. How can I set multiple nets on different parts of a track so the autorouter will one make wide a wide track for the parts that are needed to be wide? #PCB#
jeroenst 2018-10-17 15:31:46 comment 6 0 Circuit Design
Autorouter weak?
When I use the autorouter functionality, most of the times it doesn't even start. When moving a component 1mm sometimes the routing suddenly works. Also very often it can't complete the routing, altough the solution is very simple (I can do it by hand in 5 seconds when I stop the autorouting)/ Am I doing something wrong or is the autorouting very weak? Settings: General Clearance : 2mm (because of 230 volt) Track width: 0,5mm 1 bottom layer #PCB#
jeroenst 2018-10-13 18:07:56 comment 11 0 Circuit Design