asdasdasd
Simple RC waveforms are distorded after being saved the restored
I made some simulation for very simple RC and CR ciruits. When I run the transient simulation waveforms I obtain are correct. Even the curves shown in the project are nice curves. But when re-opened they are "strange" as if there was missing data. see project : https://easyeda.com/jmter/Filtres_RC_CR-1I4Oyi2M7 What happens ? I also tried to save csv data and in execl , curves are bad !! (excel files in the project also) Thank you to tell me if I made something Wrong ? #Simulation#
jmter 2016-04-15 17:58:44 comment 2 0 Circuit Design
"Ask a question" and "Let's Chat" buttons hide parameters list in editor
In the editor screen, The "Ask a question" blue button is installed at bottom right corner of the screen. Very usefull ! But this button is over the parameters list and hides the last parameter. link to screen 1 And sometimes, the "Let's Chat" button is over the previous blue button !!! link to screen 2 One solution I found is to change the internet explorer zoom.... But when not at 100% zoom, some wires disapears... so not a good solution ! Another way is to work at full screen but the 2 buttons are at the same place : link to screen 3 I tried with Firefox v45.0.2 and Chrome v49.0.2623.112 and IE v11.0.9600.18230 : same behavior Maybe my screen resolution : 1366 * 768 (laptop) is not in the standards ? Is ther a way to hide, move these buttons ? Or make parameters window high smaller than the high of the screen ? Thank you. JM TERRADE #BugReports#
jmter 2016-04-15 16:09:12 comment 2 0 Bug Reports
Zoom in&out with CTRL+Mouse wheel and scroll with wheel alone
Hi, is it possible to change mouse wheel control ? mouse wheel alone : actually zoom in&out => wanted : move the drawing (as vertical scrollbar) mouse wheel + CTRL : actually zoom in&out => wanted no change : zoom in&out. it will become closer to windows behavior from a lot of others softwares (word, etc...) Thank you. JM #FeatureRequests#
jmter 2016-04-12 18:25:08 comment 0 0 Feature Requests
Supply value causes simulation errors for a NOR flipFlop
Hi, in this project A NOR flipFlop receives signals from 2 PWL sources. I need the circuit to run at 12V. PWL alone creates good waveforms. When connected to the NOR gates, errors occurs. I tried with PWL and NOR gates at 5V, all is ok. Even with PWL at 12V and NOR supply from 5 to 8V : it simulates .... but output swing is between 0V and 8V When supply is 9V or more, simulation produces errors : 5 errors : "Warning : voltage source v2 has non-increasing PWL time points." 6 eroors : "Warning : voltage source v1 has non-increasing PWL time points." The error file is in the project. 2 circuit are inside the public project : Bad one : NOR flipflop - PWL 12V - supply 9V Good one : NOR flipflop - PWL 12V - supply 8V #Simulation#
jmter 2016-04-10 00:43:06 comment 22 0 Circuit Design
RC and 4093 didn't simulate : initial settings for capacitor ?
Hi, I tri ti simulate an RC and 4093 oscillator. But it doesn't simulate. I think it is maybe a problem with initial settings for capacitor ? Or the 4093 (SCHMITTNAND2EE) can not simulate ? Can someone help me ? TRhank you. JM #Simulation#
jmter 2016-04-02 22:40:46 comment 17 0 Circuit Design