asdasdasd
Different results simulating the same netlist under EasyEDA and ngspice
Hi! I obtained the below strange result simulating the operating point of the schematic fully_differential_unity_gain_buffer of my multisheet project LIA_testboard (https://easyeda.com/editor#id=t3leUc60i). * EasyEDA result ***** Operating Point Simulation results: +3v: -0.033617981192V voltage v(volprobe3): -0.01209V voltage v(volprobe4): -0.01209V voltage Circuit: fully_differential_unity_gain_buffer Doing analysis at TEMP = 27.000000 and TNOM = 27.000000 Warning: v2: no DC value, transient time 0 value used Warning: v3: no DC value, transient time 0 value used No. of Data Rows : 1 ngspice-26 done * EasyEDA result ***** I then generated the netlist and copied it to http://www.ngspice.com/index.php and just changed the .control block by the .op command, as this web interface to ngspice do not support the .control block and simulated, obtaining the expected result. * ngspice result ***** 0 v(volprobe2) voltage 0 2.995575136386290e+00 32 v(volprobe4) voltage 8.990835684303878e-01 34 v(volprobe3) voltage 8.991239566547913e-01 104 v(volprobe1) voltage 1.797849754862354e+00 * ngspice result ***** Is this a bug? or am I doing, one more time, something wrong? #Simulation#
joaoff 2016-04-28 16:40:37 comment 13 0 Circuit Design
Netlist generation shows just one subcircuit
I perceived a strange behavior. When a schematic has more than one subcircuit, as the one in the figure, just one of the subcircuit is netlisted. The others are ignored. Can anyone confirm this behavior? Or am I doing something wrong? #Simulation#
joaoff 2016-04-23 13:51:01 comment 3 0 Circuit Design
Attaching a .subckt to a symbol
Hi! I am trying to simulate a simple voltage regulator circuit (see image below). I found that there is no spice model associated with LM7812CT schematic symbol of the library (the symbol contributor is KiCad). I was following the tutorial "Attaching a .subckt to a symbol 02" in https://easyeda.com/example/Spice_tutorials_02-YxrJ1Vd7p. But, when I paste the model description in the text box, the model turns to a single line (as in the figure). What am I doing wrong? do I have to enter model line by line? Thank you! #Simulation#
joaoff 2016-04-23 02:37:27 comment 13 0 Circuit Design