resistor values for GM12041ARDZ-R7
The formula listed in the datasheet is 1.21v * R1 + R2 / R2 Going off that I'm using 12k for R1 and 3.9k for R2. This should yield (close to) 5v but it doesn't it yields (close to) 2.9v I have 15 copies of this PCB and all of them are the same way so it's not just the one PCB. This LDO is pin compatable with the LT1963 so I used resistor values suitable for that part, maybe the values for both resistors need to be higher or lower? The datasheet doesn't give any examples of aappropriate resistor values just the formula. I can easily replace the resstors but first I need to figure out what the correct values actually are. Atttached is the cuircuit I am using. EDIt So I think I have figured it out, the datasheet is completely wrong about the referance voltage it's close to 0.706v not 1.21v #Coupon#