asdasdasd
How to make them v-cut this board
Hi, I made a little project and it consists of 4 boards with same size. Every board has different stuff on it and I wondered if the way I did it will work with JLCPCB. What I did was making a bigger board (7cm by 7cm) and placing two board layout lines crossing at the center, thus making it into 4 3.5cm by 3.5cm boards. Or should I use mechanical layer to place these lines? #PCB#
kjur18 2019-05-19 20:02:02 comment 2 0 Circuit Design
Ability to resize preview in search libraries view and results selecting with arrow keys
Hi, now, when you resize a search libraries window, the only thig that gets resized with it is results table. When I click on one of the results I get small preview windows on the right, but they are very small. Would it be possible to be able to "grab" and move that vertical divider between search results and previews? Or at least make them resizable with window resize? I know I can click on preview and see datails in editor, but when it's nat what you need then you need still need to click libraries on the left of the window and so on. Also in libraries search results it would be nice to be able select items with key arrows, now it's only scrolls whole results, without selecting next/previous one. It would be very helpful when you need to find a particular part, much faster than clicking with mouse. #FeatureRequests#
kjur18 2019-04-22 10:47:59 comment 1 0 Feature Requests
3D view shows rotated pads
I have a project with few capacitors angled some angle. When I try 3D view I see that some of them have pads rotated a bit. On Photo view these pads look normal. On firefox it's the same. #BugReports#
kjur18 2019-01-20 12:10:07 comment 1 0 Bug Reports