asdasdasd
EasyEDA(Standard) Need help with PCB
This is the close-up image that could not be inserted into my last post: #PCB#
krisby 2026-03-28 15:45:16 comment 6 1 Circuit Design
EasyEDA(Standard) Is this PCB OK, so far?
Hello. I am a Newbie to the EasyEDA (Std.), having failed to make headway in KiCad, I migrated to this site. I am currently working on my first project, which is a PCB that has mounted on it a SMD balun (transformer). The purpose of this balun PCB is to transform the 200+ Ohm balanced RF signal (778 MHz) of a Folded Dipole antenna down to the 50 Ohm coax cable. The PCB will be attached to the antenna, and the coax cable will carry the signals (LTE) down from my rooftop to the external antenna input of my mobile (cell) phone. I have been struggling for days to try to get the two feed-in traces on the board, that connect to the secondary windings of the balun/transformer, to be balanced and symetrical so there will be no RF diferences in impedence. I have tried every thing I can to achieve this, and the attached screenshot shows the unsymetrical placements of the tracks, where they connect to their respective pins on the balun. I have also tried to attach a close-up screenshot of the relevant issue, but these forum posts only appear to allow one image per post. My understanding is that EasyEDA std does not have the function where I can enter X and Y coordinates, and the end nodes of the traces will then align themselves to those coordinates. So, does anyone have any idea how traces/tracks can be placed exactly to the designated grid coordinates? In the screen shot of the entire PCB, J1 and J2 at the top of the board will be screw holes for securing the PCB to the antenna element, as well as carrying the signals to the balun. J3 and J4 will be the connections to the coax shield braid and the central signal wire, respectively. I would much appreciate any light that could be shed upon my ignorance! Krisby. #PCB#
krisby 2026-03-28 15:40:07 comment 5 0 Circuit Design
EasyEDA(Standard)
Hello, I just started to make a circuit on the schematic page, having added a symbol for a SMD LTE Transformer/Balun (T1), part of a project to build an antenna, and have drawn four wires connected to the four relevant pins on T1. On the future PCB I hope to create, two of those wires will be connected to the dipole element of an antenna, and the other two will be connected to the coax cable. So, my questions are: 1.) Where can I find the symbols for the wires to terminate to? 2.) To what extent is it relevant to apply connector symbols at the ends of the wires, in order to progress to the PCB Editor, where footprints will be necessary. #Schematic#
krisby 2026-03-22 14:14:40 comment 1 0 Circuit Design