My final product was flawed
I did not pay attention to the PCB lay out but when I got my product the PCB layout did not match the Schematic and it had two positive out puts on both sides of a capacitor, which burned up my chip.. Please help.. #PCB#
Update Auto Router
So I did a Auto router and it worked well with a some manual routing, but I had to go back to the schematic and change out a dozen components. Now when I try to do Auto router it want update all of the components. How do I update auto router? #PCB#
arranging components in the PCB layout
There has to be another way to arrange the components in the PCB Layout. I does not make sense to have placed all these components in their proper place, in the schematic layout, to just replace them in the PCB layout, twisting them around to line the wiring up, if you have tons of components. #PCB#
Cross Probe and Place
When I select my schematic in the Project and click Cross Probe and Place, I get this error: The Object you selected is not found in other documents. #PCB#
microchip
on the EasyEDA schematic microchip components, listed in the libraries, the pins are not lined up by the physical placement of the pins on the actual microchip. So if I attach the wires on the schematic exactly where they go to other components will they line up properly on the PCB layout? #Schematic#
The whole component will not drag all at once.
When I would place components on the schematic, I use to be able to drag the whole component all at once. Now When I drag, the middle part of the component moves but the outside stays in place, and I have to drag outside seperately in place. This is serious non-productive. I need help asap.. #Schematic#