Card Edge Connector with Gold Fingers
I've created a Card Edge Adapter to 34 Pin for 3.5" Floppy Drives, to be used on CP/M Computers. My traces (Top & Bottom) I want to be non plated with RED & BLUE. I've tried drawing the 52mil traces to the edge, past the edge, and the only way I could get no errors with DRC is to stop way short of the Border Outline. So, how can I get my 52mil traces to the Border Outline without the DRC errors, and have them be Gold Fingers. The NPTH option doesn't work because I can't get double sided to work, and I can't put a NPTH on the Bottom. I'd appreciate a short example with the proper method. A DAY AND HALF LATER................... Early this morning, I located PCB_EDGE_CONNECTOR_6x2, so I edited it and created a PCB_EDGE_CONNECTOR_17x2 in the PCB editor. So, I modified my PCB artwork for my Floppy Adapter. Why is there no Card Edge Connector SCH or PCB for 34 Pin, 50 Pin Floppy's? I've created two files PCB_EDGE_CONNECTOR_25X2 & PCB_EDGE_CONNECTOR_17X2, but for some reason I get an error when I make the two Connectors (34 & 50 Pin) for each Floppy Drive. How can I send these files to someone who can help finish generating the library part files? Larry #PCB#
LM317 - TO220 case Pins and Pin lettering are incorrect.
BUG Concise problem statement: The first two choices for LM317 have the Pinouts Incorrect. Steps to reproduce bug: Select LM317 in TO220 Case (choice 1 or 2) and insert into any Schematic. Download LM317 Specification Sheet and get documentation for Pin 1, 2 & 3. Compare EasyEDA LM317 Part (choice 1 or 2) to Specification sheet Results: Pins are incorrectly labeled for first two choices in EasyEDA. Expected results: Correct Pins are Pin 1 = ADJUST (Left), Pin 2 = OUTPUT (Center & TAB), Pin 3 = INPUT (Right) Browser: Firefox-ESR 45.8.0 (Debian 8.x) 32 Bit #BugReports#