"can't find your file" error message
When I open EasyEDA i get the following error message: I just click OK and it goes away, and I have no further problem, but I would like to stop getting the error message. I don't know what this file is from. How do I fix this? #Schematic#
Can only shrink PARTS window. Cannot increase size
BUG Concise problem statement: Tried on two different Widows 10 PCs with Chrome browser. When editing a schematic, when I click on the "PARTS" icon at left, a parts list window opens. If I try to resize the window, I can only make it smaller. That would be OK, but once I attempt to resize by clicking on the window edge and getting a double-arrow (for resizing windows), I cannot get OUT of that mode (with with either right click or ESC) so any mouse motion only serves to reduce the window. Window resizing is only one direction, down, so I cannot even undo accidental window reductions. I have to completely exit EasyEDA and start over and make sure I don't touch the PARTS window edge to use the PARTS list. Steps to reproduce bug: IN schematic edit mode, open PARTS window Try to resize parts widow and make it larger Results: Parts window can then ONLY be reduced and program will not leave window resize mode Expected results: Ability to increase or decrease PARTS window size and exit resize mode with right click or ESC Browser: Chrome #BugReports#
How to deal with off board potentiometers?
I have off-board potentiometers in my schematic, but for starters I just grabbed some generic potentiometers from a library to get my schematic drawn. Now I want to lay out a PCB, and I (of course) see my four pots shown as on-board trim pots. I want to change the PCB to three pads each, to connect wires to panel-mounted pots. I don't care what the schematic looks like so I first tried replacing the pots with 3-pin headers, but when I try to update the PCB from the schematic I get a package error. The same thing happened when I tried to replace the header with 3 test points. What am I doing wrong and how is normally done? #Schematic#
Can I place components at 45 or 60 degree angle in SCHEMATIC
I would like to draw resistor bridges or motor windings in a schematic with the elements (usually resistors or inductors) NOT horizontal or vertical, but at 45 or 60 degree angles. Is this possible? I tried a variety of keys (ALT, Fn etc) while clicking on one end of a component, hoping that I could pivot the device, but could not find any way to rotate other than 90 degrees. Is this possible in EasyEDA? #Schematic#