about the default settings
Hi all. 1. Is there a new default settings Easyeda? My software shown for example the default Via size: Via Diameter (min) : 0.61mm Via Drill Diameter(min): 0.305mm this will not easy to use for a small pcb board? I set the small via size as: Via Diameter (min) : 0.254mm Via Drill Diameter(min): 0.2mm is this OK? 2. I've got the tutorial said seems not use via and just pad? some where only need a pass from bottom to top or reverse. and made a Via in Pad seems much butter, not sure if it is correct, because of the area 'A' doesn't show the copper color as pad? WAS Via and Pad: modified as Via in Pad: 3. I found ESP32S3 model in EASYEDA's library, this one with few Via holes there, resulted lot of errors, how to fix? 4. got error on my desktop Version when offline, why the offline Version still need Internet? 5. found Easyeda library part ESP32 with lot of vias there resulted errors, how to fix, just delete the vias? Thanks #PCB#
How to check if a trace is continuity and short?
Hi all. is there a method to check the trace one by one and see if it is continuity and short? Thanks #PCB#
can Easyeda simulation Arduino controlled circuit?
Hi all. Like the picture below used Arduino UNO to control LED ON/OFF? thanks. #Schematic#
in which layer these names belong to in pcb?
Hi all. the picture shown lot of names in pcb, how to turn off them? Thanks actually few questions: 1. how to chek auto-routing resullt, like total connections, how many incompleted? 2. manually route few connections, which seem not be recognized, because the freerouting still got same incompleted by its DSN; 3. there are lot of errors, do I need clear all of them? 4. used a FPC-0.5mm connector that has Pad-Pad clearance 0.15mm, and system need 0.25mm, got errors, and it is not fixable, how to do? 5. how to batch edit like via size? #PCB#
how to deal with this kind of inside chip connection?
Hi all. the picture shown a chip with inside connections, which never can't be routed, and hard to manually do it neither, how to fix? just leave as is? Thanks. #PCB#
why the R26 doesn't router?
Hi all. the picture 1 shown the AON7403 cirduit, a portion of a design, and picture 2 shown its pcb layout, question is the R26 never routed, why? its such direchly simple? the green line is in bottom layer. should I short all D? Thanks picture 1: picture 2: #PCB#
about the router trace width set on net.
Hi all. if set width of VCC: 1mm and default: 0.2mm, what will be in picture below? the VCC in need be 1, and the capacitor C8 default, how to get there? Thanks #PCB#
Where is the blue drawing outline and how to edit it?
Hi all. met this when edit a footprint, and it can't be edited, how? Thanks #PCB#
How to put the connector in Schematic and got expected orientation in PCB?
Hi all. I put a FPC-18P connector as picture A, and got PCB locating as picture B which is opposite of what is needed, how to fix please? I also tried to mirror the connector in Schematic got same thing in PCB. Thanks Adam PICTURE A: PICTURE B: #Schematic#