asdasdasd
Resolving Design Rules Conflict for SMD Round Nut Placement
Hello everyone, I am encountering an issue while attempting to position the SMD round nut from LCSC on my board (also available in the JLCPCB library): https://www.lcsc.com/product-detail/SMD-round-nut_Sinhoo-SMTWE2015MTJ_C2928176.html The design rule check (DRC) indicates a requirement of 0.152mm, whereas the nut's polygons have a solder mask of 0.050mm. I attempted to amend the Design Rules for the nuts to a clearance of 0.05mm, which unfortunately didn’t rectify the issue. I'm uncertain if this adjustment is correct. I seek guidance on how to resolve this, and understanding the root cause. Could there be a mistake on my part in utilizing these nuts? Project URL: https://oshwlab.com/logronoide/solderless-raspberry-pi-pico Warm regards. #PCB#
logronoide 2023-10-16 05:28:46 comment 6 0 Circuit Design