asdasdasd
Is an half pad hole on pcb edge solderable?
I have set a pad to 50% on the pcb edge, in order do solder it to an RGB-LED stripe later. I want to have the same result compared to an ESP8266. There you also have a solderable hole-half. Will this here have the same effect? Or do I have to use a special function for this? #PCB#
magie004 2023-07-09 07:19:28 comment 2 0 Circuit Design
How to fully connect annular rings with copper layer ?
At the moment my annular ring is connected over "bridges". Since I will have big currents, I want to use as much copper for the connection as possible. How can I do that? Refering to the image the VCC-Pins shouldn't have gaps to the blue layer: #PCB#
magie004 2023-07-04 04:06:55 comment 6 0 Circuit Design