Understanding Net labels and Design Rules for efficient auto-routing.
Hello, I’m new to EasyEDA and trying to understand net labels and design rules for efficient auto-routing. 12V comes from the barrel jack and goes through the fuse, diode, and capacitors before reaching the terminal block. I labeled +12V between the fuse and barrel jack, expecting it to apply to the entire 12V net. However, in the PCB layout, only the section before the fuse is recognized as 12V. I want all 12V traces to be thicker using auto-route, but currently, I have to manually adjust the rest. ❓ Do I need to label +12V before the fuse, after the fuse, and after the diode separately? ❓ Or is there a better way to ensure all 12V traces are recognized as one for auto-routing? Thanks for your help! #PCB#
Is It Possible to Use Auto Route with Round Corners in EasyEDA Standard Edition?
Hi, I am using the standard edition of EasyEDA, and I want to know if there is a way to configure the Auto Route tool to use round corners instead of sharp or 45-degree angles when routing traces. I’ve looked through the routing settings but couldn’t find an option to directly enable rounded routing during auto-routing. Is this feature available, or is there a workaround to achieve rounded corners automatically during routing? Any guidance or suggestions would be greatly appreciated. Thank you! #PCB#
Request for Schematic Review for my PCB
Hi everyone, I’ve been working on a PCB design and have made several tweaks along the way after facing a few challenges (burning a couple of boards during testing!). I believe I’ve addressed the issues, but I’d really appreciate it if you could review my schematic and share your thoughts. If you spot any errors or have suggestions for improvement, I’d be grateful for your input! Thanks so much for your time and help! #Schematic#