Ceramic Chip Antenna Advice
Hi all: Am trying to learn more about ceramic chip antennas. I found this webpage: Chip Antenna Layout for 802.11 Applications - Johanson TechnologyI have seen a lot of datasheets with drawings similar to these. Before I even get to the point of trying to design a circuit, impedance match, design pi filter, etc. I have some basic questions about these datasheets. For example, I see vias which makes me think there is a dedicated Ground layer, but there is also the large "orange" layer in the figures which is labeled "Ground". So is this saying if I have a dedicated ground layer that I should also have a solid "Ground" region on my top (signal) layer and connect them with vias? I am assuming that large orange area labeled "ground" is on the top layer because the microstripline and pads for the antenna are also orange. Or maybe this is just for a 2 layer board? Also, what is the grey area around the microstripline? Any help is appreciated. #GeneralDiscuss#
Question for a Beginner
Hi All - I am just getting into PCB design and have a question on this schematic: Component U2 is a voltage regulator ME6211C33 and the VOUT goes to a 10uF and 100nF capacitors between +3.3V and GND. Now if you look at U1, the esp32-c3 pins 2 and 3 are connected but on the other side of the inductor L2 is the same arrangement of capacitors to +3.3V and GND. The question I have is this: when I try to reproduce this in easyeda, do I need this capacitor arrangement twice or once? If just once, is it included in the schematic just in case you decide to modify one? If both are required, it seems odd since they seem redundant. Thanks for any help! Fish #Schematic#
"Keep Out" zone for Antenna
Hi. New to EasyEDA. Quick question. When creating a "keepout zone" for ceramic chip antenna in EasyEDA, do I need to specify that in a certain way in EasyEDA (I plan to use JLCPCB to fab) or do I simply make sure there are no traces on any layers, ground planes, etc? I just want to learn the right way to do it in EasyEDA. Thanks! Fish #PCB#
Using a Development Board as a Component
Hi all. VERY new to creating PCBs. I have a development esp32 board that I would like to use as a component on a larger pcb...i.e. solder the header pins to the dev board then "plug" the dev board into the main pcb. I would like to have both the top and bottom layers to have access to the dev board pins. I created a footprint for the dev board on the main pcb and then put 1mm diameter holes (0.04") in the center of the pads. Is that it? I assumed I would need to put pads on the top and bottom layers...but not sure if I need to and if so, how to do it. Any help would be helpful. Thanks! Mark #PCB#