Through-hole pins not connecting to power plan
So this is a common problem people have, tons of posts about not getting connections to internal power or ground planes. I have done a dozen 4-layer designs in Easyeda and (thought) I understood how it works, but on my latest design... I cannot get the through-hole pins on the power net to get automaticallyl connected to the internal power plan (they remain as ratlines to be manually routed). So here I think are all the relevent bits that taken together, I thought, should work (netflag on power net, net name matches PCB layer name, PCB layer is "Plane" type, board outline has no gaps, PCB planes have been rebuilt, the power plane covers all area inside the board outline. Schematic: Power net is named "3V3" and has a netflag named "3V3". Notice + side of C9 is connected to net "3V3". PCB Layer Manager: Here is that C9 component. Just did Shift-B to make sure all copper is rebuilt. With the 3V3 layer selected you can see the + terminal is isolated from the 3V3 plane, but the netname on that ratline is 3V3. So why is that + pin not connected to the 3V3 plane? C9 is just one example, every place a pin should connect to the 3V3 plane, it does not. What else is there? I am stumped! #PCB#
Show net names in schematic editor
This is so obvious I cannot believe this feature does not exist, but all my research finds no way to do it. Request: When a net is selected in the schematic editor, show the name(s) of that net somewhere in the UI (properties panel for the selected wire would be an obvious place). If there are multiple names, show all of them. From what I can tell, there is NO WAY to find the name of a network in the schematic unless (1) there is a user-created Port label, or (2) you select it in the Design Manager and it is highlighted. If you don't know the (generated) name it is impossible to find it in Design Manager without clicking on every single net which is not practical for large designs. Here is just one scenario where this is needed: I am auto-routing a PCB and I want to use the "Skip Nets" feature to prevent auto-routing of certain nets. There is a drop-list of net names to choose from for skipping: Obviously I know exactly what net in the schematic I want to skip routing, but I have no idea what the generated name is. So I have to dismiss the Auto Router Config dialog and find one of the components connected to the net of interest, and see the net name on the PCB. Now I re-open the Auto Router Config and choose that net to skip. Then I do that again for the next one I want to skip. It is absurd. I don't care where or how (tooltip, properties panel, whatever) but make some way to easily show the name of a selected net in the schematic editor. #Schematic#
Schematic net warnings are not being displayed
I am getting warnings on nets in my schematic design, but I cannot see the actual text of the warning so I don't know what it is warning about. The tutorial shows the warning text in yellow below the pin list for the selected net, but nothing is showing up for me: What is (potentially) wrong with the selected net? There is no warning text, only the icon... #Schematic#