Expand track width after component connection
Hello, I am using a standard 2 pin screw terminal connector on one of my pcbs (con_terminal_block_02-5). The variety I have are supposedly capable of handling 10A\, though I will only be using up to 7A. Track width calculators tell me that I should be using a track width of around 170mil\, however easyEDA will not allow me to make the track over 90mil wide\, I am assuming because it would be interfere with the opposite pin of the terminal connector. I think I really need the track to be 90mil at the pin of the terminal and then expand to 170mil for a stretch before reducing again to make its final connection. In easyEDA it seems like the tracks can only be a single width for the entire length of the track. Is there any way for me to expand the track width mid track? Thanks -Michael #PCB#