Track to Pad Errors (and others)
Another newbie to EasyEDA. I created a schematic for a board with 2 DPDT relays and a few other parts (snubber diode, LED/resistor, etc.) where the relay NO, Common and NC connections are intended to have pads for external wiring. They are intended to carry fairly heavy current so I set the Pads at 3mm and Holes at 1.789mm. I couldn't find anything for the schematic for a pad output, so I left them unattached. When I created the PCB, I added the Pads and Tracks. However the DRC check shows Errors, (Picture here) 31 of them for the pads and the traces that I added. I couldn't find out why!!! So, I went back to the schematic and re-created the PCB and tried to add just one connection , and of course it shows a DRC Error: gge3254-gge3248 (-3mm, need more than DRC (0.152mm) A picture of the Error is here. (I couldn't get the forum to show the picture) This is the single error just to play with but I can't find a solution. I can't figure out what to do! I have another VERY similar board that I created and it doesn't have any errors, shown here. Mike #PCB#