asdasdasd
Removing non-functional pads
Hi, I'm looking for a way to remove non-functional pads on vias on a 4 layer design. E.g. when a via is connecting the top layer and inner 2 then I don't need pads on inner 1 and bottom for this via which should allow save space on clearances on these layers. Is it possible with Easy EDA? Thanks, Aleksey #PCB#
missile666 2019-08-26 00:12:45 comment 2 0 Circuit Design
Connecting VCC through a solid region makes VCC look unrouted
I've tried using 2 solid regions to connect different VCC areas on my PCB but it would mark up the VCC net as unrouted in the nets list. Replacing the solid regions with direct trace connections removes the unrouted warning. Is the only workaround is to first connect everything with tracks and then put a solid region on top? Is there a better way to fix this? #PCB#
missile666 2018-12-12 07:18:23 comment 3 0 Circuit Design
Routing width goes back to a memorized setting when I don't need it
After increasing the track width with the +/- keyboard shortcut I then change it manually in the properties window to 0.152mm. Then I use the track tool and it works fine for the first time. When I try to use the track tool for the second time though it would jump to that previous wide track width. It looks as though it has memorized the track width for the GND net and would use that overriding what I'm trying to set manually. How do I keep my manual routing width setting from being overwritten? #PCB#
missile666 2018-12-10 04:04:48 comment 0 0 Circuit Design
Setting the minimum routing width when using the +/- shortcuts
When I set the Routing Width manually in the properties window I can set it to 6 min (0.152mm) and it works fine. When I start changing the track width while routing using the +/- keyboard shortcuts it won't let me go below 8 mil. Is it possible to go down to 6 mil when using the +/- shortcut? #PCB#
missile666 2018-12-10 04:00:16 comment 0 0 Circuit Design