asdasdasd
Can I place a component overhanging the board outline?
I want to be able to take a multi-pin connector and place it on the PCB so that part of the housing of the connector hangs over the board edge. The through-holes for the connector pins are still inside the board outline by more than the DRC clearance value. Is this possible? I don't see any information in the tutorial or the forums. #PCB#
mlefevre 2019-12-31 06:29:10 comment 2 0 Circuit Design
Switching to Rev 2 creates a duplicate component
After getting my prototype PCBs back from JLCPCB, I needed to make some changes. I created a Rev 2 of my project and edited the schematic. The changes were to replace 3 connectors with new ones that were the right size. I then transferred the changes to the PCB layout workspace. Included with the connector changes was the addition of R10 which exists in the schematic one time and has been there from early saves of Rev 1. Where did this resistor come from and what should I do with it? #BugReports#
mlefevre 2019-12-31 02:30:41 comment 0 0 Bug Reports