eelib resistors
Hello, when selecting a resistor from the eelib selection, do I just need to name the resistor with the value I need for JLCPCB to assemble my pcb, or do I need to go into the extended library and find the right value resistor to use in my schematic? thank you. #GeneralDiscuss#
Dsub 25 pin connector
Hello, can you tell me why the pin out of the dsub 25 pin male connector is different than the same connector in the female type? I’m looking at part# C77838, the female type, and, part# C75751, the male type. The male connector has pin 1 in the top right corner, and the female has it in the bottom right corner. If I were to use the standard dsub 25 pin breakout board to connect to this connector, will pin 1 correspond to what pin 1 is on the breakout board? I am just looking for some consistency when I go to hook up accessories to these pins. I’m not using these connectors to communicate serially, but as individual channels for different purposes. Thank you! #GeneralDiscuss#
GND Net Issues
Hello, I am having trouble understanding why my GND nets are saying they are not connected on my PCB layout relay module mark V. Everything looks connect yet it still says there is a missing connection. Any help would be greatly appreciated! Thank you! Michael #PCB#
UNABLE TO RENAME NETS, SAVE/ UNDO BUTTONS GRAYED OUT, CANT SAVE OR UNDO
Hello, I am having trouble with my relay module second half PCB layout. in the left hand tab, I rename a net, however, it doesn't actually change when I hit the refresh button next to the nets folder. I am also unable to use the save function or the undo function. Is there a way to delete all net names? I don't want to delete the nets or there connections, I just need to rename them all. the reason for this is because I am building a large pcb, and if I try and do it in one schematic, the software moves so slow that it literally take a full minute to route one track, like I rout a track, then it thinks for a full minute before I can start connecting another net. so I need to break up my design into two parts. the reason my two designs are identical, however I cant copy and paste it to a new PCB because the nets will have the same name, so I need a way to change the nets and then a way to save the file when im done. #BugReports#