Possible new view mode
I would like you to consider a new PCB board view mode. This mode would flip the board over for a view from the bottom layer side. It would aid in trouble shooting the board.This mode would have all the current display feature as the top layer view currentlly used but be from the prospective of the bottom layer. It would also be useful for laying out boards with componets on both sides of board. #PCB#
Mirror image of PCB
I would like to see a "mirror" view of the PCB as an option. Basically a rear view of PCB with all the "highlighting" options still available. I like to hand wire a board before sending it off for production and it would be handy if there was a mirrored view of the PCB that would show the various nets highlighted as the normal view currently does. It would enhance the building of a prototype board before the final production. These boards are typically thru hole versions to test the circuit. #PCB#
preventing autoroute from crossing mounting pads for screws
I have a project with four mounting holes with square pads for screws that the autorouter keeps running lines thru. How do I tell the router it can't go there? The pads are "locked" in properties. What else do I need to do to keep them isolated as any metal mounting screw would short the circuit to the pad and therefore what ever it's mounted to! #PCB#
Change operation of "selecting" a line in schmatic
At present when you selcet a line in a schematic it highlights just a section of the line. Is it possible to either change that behavior or add something like shift-select to highlight every connection made by that line? It appears that sometimes connections are not actually made and this would be a way to visually verify where each "net" goes? I think it would greatly aid verifing a schematic. #Schematic#
renaming projects
Is there any way to rename a project after it is started?? Seems like a fundamental capability but does not appear to be implemented. #Schematic#
net highlighting
In other tools I have used there was an option to select a line of a schematic and have it highlight every connection. This doesn't seem to be the case in easyeda. Am I missing something? Currently if I select a line it only highlights a segment of the line. By having the ability to highlight a whole net it is easier to trouble shoot connection problem and also highlight mis-connections. I under stand there is a net list but that is not as visual as schematic highlighting. I recently ordered a set of boards only to discover a line crossing a ground line had been connected and it was overlooked. Is this capabilty present in easyEDA and I just have not discovered it yet? Maybe something like \.select?? would work?? Thanks for any help. #Schematic#