asdasdasd
DC-DB buck converter module
H I've been very pleased with EasyEDA thanks and have just got my latest set of PCBs from JLCPCB. I'd like to include a mini DC-DC buck converter module in my latest project. Specifically, I'd like to have a block diagram of the device with the inputs and outputs in the schematic and then be able to place the equivalent module during the PCB design. If there's an existing equivalent module then I can't find. So, what would I need to create to allow me to do this ? Thanks #Schematic#
netdudeuk 2022-11-27 23:52:34 comment 1 0 Circuit Design
Lolin D1 Mini V4.0.0 support
Hi Please does anyone know if there's been any community support added for the Lolin D1 Mini V4.0.0 (like this) ? I've searched for a while but cannot find it. Thanks #GeneralDiscuss#
netdudeuk 2022-04-05 20:43:47 comment 5 0 Others
Big PCB fail - nets don't match schematic
Hi Regarding my Nixie display board - master project I got the PCBs from JLPCB yesterday and was very pleased with them. However, having soldered on the Nixie sockets and a couple of other components, I found that I could not light up a Nixie tube properly. I did some research and found that the connections from the driver ICs in the schematic (which look correct) are not matched by the nets / tracks on the PCB. For example, pin 1 on NIXIE2 should go to R2 but it actually goes to pin 10 on U4. It's actually pin 5 on NIXIE2 that goes to R2. Etc., etc. I asked the software to create a new PCB and there again, the nets are aligned like this. So, that's five PCBs (£££), some other parts and three weeks wasted. Why would this be ? Thanks #PCB#
netdudeuk 2020-07-18 19:21:51 comment 10 0 Circuit Design