Help with my first (second revision) pcb board – thanks in advanced to everyone
Got my first boards from jlcpcb! Super rewarding, but ready for rev2. I got my 'rev1' version of the board that I used for prototyping, everything worked sans a few of my own screw ups (the buttons were surface mount when I meant through hole & I forgot to wire up my I2C resistors, doh!) - but I was able to test everything with some improvising and ready for a few revisions! I included the EDA link for r2 below, things I changed were really around fixing my dohs, power distribution, and making board a bit smaller. In rev1 I also had the switch for 2 power sources (board & dedicated servo) – but for rev2 I rather have 1 power source if i can. Can I get away with powering the board + 2 servos with the 6v 3a dc power in the way I have it drawn? Would be 2 micro servos that max out at around 750ma. For rev1 I also did 2 layer pcb with the bottom layer containing a ground plane – it was suggested prior to do 4 layer pcb, with layer 2/3 being ground planes - thoughts? I also posted this on Reddit and got some slack for the autorouting in easyeda and was suggested I do more manual or even use vias for 5v/vcc/gnd and reserver traces for signal. Is that the way? Thank you all, apprecite the support! PSA: I'm a novice when it comes to this – I'm a software engineer, but really love playing around with hardware, so be easy on me. – Nick (https://www.nleby.com) Project Link: https://oshwlab.com/nicholasleby/tc-v1-0 Some pics of the r1 board I did with easyeda and jlcpcb: #PCB#