create pads
Hello, to be clear: I'm a total beginner. I created a schematic for a 5V voltage regulator. In there I have 3 nets (Vin, Vout, GND). How can I assign pads that net so that I can attach wires to it? #PCB#
copper pour does not fill
Hello, In my schematic I dont have a ground component included (only a pad that will be connected to a Battery minus contact). So obviously, there's no GND net in this schematic. In the PCB editor, the copper fill does not apply unless I add a GND connection. How do I achieve the copper fill without a GND net? #PCB#
Adjust pad size
Hi folks, I need some help adjusting the pad size. I only found HDR1x1 but the hole and pad are way too small. Is there an easy way to search for a suitable pad / hole size? Thanks #PCB#