How to make new IC component?
Hi I am trying to add a microcontroller to a project I didn't find in a list. It's a SOIC14 package. How can I go about making the microcontroller schematic and PCB outline? #Schematic#
solder pot method for soldering small boards quickly?
Has anyone used a solder pot to solder a PCB with through-hole components? I have a 50mm square PCB but I have many of them and it's going slow with 15 components each. I have seen these solder pots online https://www.amazon.com/gp/product/B01HHKROR2/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1 and I was wondering are these used to solder entire boards at once successfully? I haven't seen it done or know of any use of this method, just something I thought of. Or does anyone know of another method that is fast for soldering through-hole boards besides individually one-by-one ? Thanks #Skill#
First time assembling PCBs with through-hole parts questions
I am assembling PCBs for the first time that I designed with EasyEDA. The components are thru-hole and there is a ground plane that many components are connected to. The PCBs made by standard processes at a well-known supplier. Should I be concerned when soldering the pads that do not connect to the ground plane? I am concerned that there could be a short if the solder accidentally attaches to the ground plane when it should not. So far I haven't had a problem as far as I know, but this is my first PCB design, and first time doing the assembly, so I wanted to clarify that. Also, I am using a solder flux pen to wet the connections before soldering, is this a good idea? It seemed to help the flow. I have used 2 solder flux pens. One is "Rosin Flux Pen" by MG Chemicals, RA type, non corrosive. The pen I just started using is "Flux Pen for Rework" by SRA Soldering Products, No. 312 Alcohol-based, No-clean Flux. Are either of these acceptable or good to use? The SRA flux seems to work better and dries less yellowed. #Skill#
# of nets?
Hi, Is there a way to get a count of the number of nets and/or traces? Thanks, Stephen #PCB#
first time PCB maker project advice?
Hello, I am making my first PCB and I was hoping to request some help in making a good design. It is a fairly simple design with 20 components. I have a working perfboard prototype, and I have a completed schematic and an initial PCB design. Could anyone look at this and offer some advice? I am looking for low-cost, robust design with good functionality that can be make quickly, this a project for Halloween. Thank you. #PCB#