ammeter symbol in most tutorial examples acts like an open circuit
I have been going through the simulation tutorial. In many of the example is an ammeter symbol. In most cases when I try to simulate those example I get unexpected results. Putting a 1 ohm resister across the ammeter gives the expected (at least in my view) results. #BugReports#
tutorial examples - ammeter seems to be an open circuit
At least two spice simulation tutorials have examples that don't run correctly because the ammeter in the circuit seems to be an open circuit The second one is in Advanced probing and simulation control, Using CTRL+R to run a simulation directly The first I only have the URL of the example, it was about using NetLabels. https://easyeda.com/editor#id=f0813f811ee948468bfc80cc3a9bcbb0 Also the example "Setting initial circuit conditions 03" #Simulation#
Help requested on simulating an OP amp
Very new to EasyEDA & nspice. I have been reading the tutorials. Any guidance would be appreciated. Just trying a simple OP Amp LF356N, which I got out of the library/SCH libs/system I finally got the simulations to run without an error, but the output pin (and the - input pin) don't register an output on any of the simulations (transient, AC analysis, DC sweep etc. I see on the simulation plots the Sin wave of the AC source, but not on Volprobe 1, which should have a gain of about 3.3 Do I have to make up the OP Amp and insert the spice code? here is the project, again any guidance would be appreciated. Active file's owner project page https://easyeda.com/phillman5/shared-simple-op-amp Active project editor page https://easyeda.com/editor#id=|f79a39fbeeb847c1bc9e1043b6d327d0 Thanks in advance! #Simulation#